Is it possible to turn on the oven using an extension cord?
The main nuances of connecting modern ovens to an apartment. Top 3 best manufacturers common connection errors
- What power of the purchased cabinet is allowed for a safe and reliable connection to the old home outlet? a) 3.5 kW.
b) 4 kW. - In what case will the owner of the apartment have to replace the wires in the room in order to install a cabinet? a) If the renovation with a complete replacement of electrical wires was carried out a year ago.
b) If he lives in a “Khrushchev” building and repairs and replacement of wires have not been carried out for many years. - What is the distance between the bottom of the equipment and the floor? a) 2 cm.
b) 3 cm or even 3.5.c) 5 cm or increase to 8.
- What color is the protective layer of the phase made and what terminal is it connected to? a) Brown.
Connects to "L". b) Green. Connects to "PE".
Answers:
- a) To reliably connect to the old outlet, the cabinet must have a power of no more than 3.5 kW.
- b) If a person lives in an old house like a Khrushchev, and the renovation was done many years ago, then before installing the cabinet, all wiring will have to be replaced.
- c) The distance between the bottom of the cabinet and the floor is at least 5 cm. If possible, it is advisable to increase this number to 8 cm.
- a) The phase is covered with a brown protective coating and must be connected to the “L” terminal.
The oven has many advantages over its gas counterparts - the device is successfully used as a microwave, oven, or electric grill. In addition, if you wish, you can try to connect the device to the network in the kitchen yourself, without calling a special worker. But to connect it, you will need to thoroughly understand the topic. After this, it will be clear how to properly connect the oven to the power supply.
Definition: An oven is a built-in piece of kitchen equipment for cooking.
How to connect an electric oven to the network? We answer questions and follow recommendations.
Connecting the cable/cord to the oven
Connecting an oven often involves the need to connect a cable or cord. For these purposes, there is a terminal block on the rear wall of the case. It is covered with a lid. The cover can be metal or plastic, held on by latches or screws. The options vary from manufacturer to manufacturer, but it’s impossible to make a mistake—there’s nothing else.
To 220 V network
First, remove the cover. Under it we see terminals with multi-colored wires connected on one side. If you are going to connect the oven to a 220 V network, there will be many more terminals than wires. Some are connected by jumpers. They must be installed, but can be checked. In general, the jumper installation diagram must be on the case. It can be embossed (as in the photo) or painted on (sticker).
What jumpers should be placed on the oven when connecting to a 220 V network?
For a single-phase 220 V network there must be three jumpers. Two phases connect - the first, second and third output. And one stands between the fourth and fifth.
Where to connect the cord
The wires from the cable/cord are connected as follows:
- To the third phase.
- By the fifth - neutral. The wire is blue or light blue.
- To zero (can be before the first or after the fifth) - grounding. With a yellow-green color.
The connection should be in exactly this sequence. Then the wires must be connected to the three-pin plug in this order: on the top pin - yellow-green, on the right - phase, on the left - zero (blue).
To 380 V network
When connecting to a three-phase network, there is only one jumper left - on the fourth and fifth terminals.
Read also: Laying signal tape over the cable
Installation of jumpers for 380 V network
Connecting the cord conductors according to the following diagram.
Connecting the cord to the oven for a three-phase network
Your repost will change the Internet
